English 
Español
Français
Português
Strub Acticide ® OX
7883301
Acticide ® OX is an oxazolidine based formaldehyde donor speciafically developed for the primary and secondary preservation of aqueous metalworking fluids, cooling and lubricanting emulsions, grinding fluids, construction chemicals and similar products.
CHEMICAL AND PHYSICAL CHARACTERISTICS
|
Composition |
bis-(5,51-dimethyl-1,3-oxazolidine-3-yl)-methane |
|
Appearance |
Clear, almost colourless liquid |
|
Odour |
Characteristic |
|
Density (20oC): |
1.040 – 1.072 g/ml |
|
pH value |
9.0 – 11.0 |
|
Amine value |
580 – 600 mg/g |
|
Solubility |
Fully soluble in water, most lower alcohols and glycols |
|
Stability in application*: |
Stable over the pH range 3 - 10 and up to 80°C |
Note: These characteristics do not constitute a sales specification
BIOCIDAL PROPERTIES
Acticide ® OX has a broad activity spectrum against bacteria, moulds and yeasts, including the following organisms:
|
Test Organisms |
||
|
Bacteria |
Fungi |
|
|
Achromobacter sp. |
Flavobacterium sp. |
Aspergillus sp. |
|
Aeromonas sp. |
Klebsiella sp. |
Penicillium sp. |
|
Alcaligenes sp. |
Proteus sp. |
Rhodotorula sp. |
|
Bacillus sp. |
Pseudomonas sp. |
Saccharomyces cerevisiae |
|
Escherichia coli |
Streptomyces sp. |
|
APPLICATIONS / USE LEVELS
Acticide ® OX is suitable for the wet state primary and secondary preservation of aqueous metalworking fluids, cooling and lubricating emulsions, grinding fluids, construction chemicals and similar products.
Normal end use concentrations are in the range 0.05 - 0.25%, depending on the product to be protected and the environmental conditions to which it will be exposed. If added to concentrated products which are subsequently diluted before use, addition levels must be adjusted accordingly. The precise level required by a specific formulation can be determined by the local Thor Microbiological Technical Centre.
ADDITION / COMPATIBILITY
Acticide ® OX can be added at any time during manufacture. However, it is advised to add it as early as possible to give protection to susceptible products throughout the production process. Care should be taken to ensure that temperature and pH at the point of addition are suitable for stability of the product. Avoid acids.
Prior to use ACTICIDE® OX must not be diluted or mixed with any other raw material to avoid negative influences on the active. Please contact our local Thor Microbiological Technical Centre for more information.
Acticide ® OX is not compatible with formaldehyde sensitive products but may be used in most other formulations in which its application is recommended. Users are advised to carry out their own tests or seek further advice from Thor prior to initial application.
ADDITION / COMPATIBILITY
Acticide ® OX can be added at any time during manufacture. However, it is advised to add it as early as possible to give protection to susceptible products throughout the production process. Care should be taken to ensure that temperature and pH at the point of addition are suitable for stability of the product. Avoid acids.
Prior to use ACTICIDE® OX must not be diluted or mixed with any other raw material to avoid negative influences on the active. Please contact our local Thor Microbiological Technical Centre for more information.
Acticide ® OX is not compatible with formaldehyde sensitive products but may be used in most other formulations in which its application is recommended. Users are advised to carry out their own tests or seek further advice from Thor prior to initial application.
No reviews
Attachments
Tap to zoom
